顺络电子：电感业务稳增长 新品下 主要看点：
主业电感稳增长。受上游供应商的影响,公司今年上半年主业增速有所下滑,目前已恢复,7月营收创出历史新高。从下游市场来看,手机依然是第一大应用领域,为应对智
The TLE983x is a single chip solution that integrates a high performance 8-bit microcontroller derived from the established XC800 family with application specific power drivers, control and communication modules in an automotive qualified new Smart-Power Technology.
The TLE983x family concept offers scalability in terms of Flash memory sizes ranging from 36kB to 64kB with pin-compatible devices.
The TLE983x family was specifically designed to fit to a wide range of LIN-slave applications where a small package form factor and a minimum number of external components is essential.
TLE983x主要特性:
• High performance XC800 core
– compatible to standard 8051 core
– up to 40 MHz clock frequency
– two clocks per machine cycle architecture
– two data pointers
• On-chip memory
– 20, 32, 44 or 60 kByte + 4 kByte Flash for program code and data (4 kByte EEPROM emulation built-in)
– 512 Byte One Time Programmable Memory (OTP)
– 512 Byte 100 Time Programmable Memory (100TP)
– 256 Byte RAM
– 3 kByte XRAM
– BootROM for startup firmware and Flash routines
• Core logic supply at 1.5 V
• On-chip OSC and PLL for clock generation
– Loss of clock detection with fail safe mode for LSS, HSS and LIN
• Watchdog timer (WDT) with programmable window feature for refresh operation and warning prior to overflow
• General-purpose I/O Port (GPIO) with wake-up capability
• Multiplication/division unit (MDU) for arithmetic calculation
• Software libraries to support floating point and MDU calculations
• Five 16-Bit timers - Timer 0, Timer 1, Timer 2, Timer 21 and Timer 3
• Capture/compare unit for PWM signal generation (CCU6) and Hall Sensor measurement with Timer 12 and Timer 13
• Full duplex serial interface (UART) with LIN support
• Synchronous serial channel (SSC)
• On-chip debug support via 2-wire Device Access Port (DAP)
• LIN Bootstrap loader (LIN BSL)
• LIN transceiver compliant to LIN 1.3, LIN 2.0 and LIN 2.1
• 2 x Low Side Switches with clamping capability incl. PWM functionality, e.g. as relay driver
• 1 or 2 x High Side Switches with cyclic sense option and PWM functionality, e.g. for LED or powering of模压电感器厂 switches
• High Voltage Monitor Input pins for wake-up and with cyclic sense and analog measurement option
• Measurement unit with 10 channels, 8-Bit A/D Converter (ADC2) and data post processing
• 8 channels, 10-Bit A/D Converter (including battery voltage and supply voltage measurement) (ADC1)
• Single power supply from 3.0 V to 27 V
• Low-dropout voltage regulators (LDO)
• Dedicated 5 V voltage regulator for external loads (e.g. hall sensor)
• Programmable window watchdog (WDT1) with independent on-chip clock source
• Optional Operational amplifier for current sensing
• Power saving modes
– MCU slow-down mode
– Stop Mode
– Sleep Mode
– Cyclic wake-up and cyclic sense during Stop Mode and Sleep Mode
• Power-on and undervoltage/brownout reset generator
• Overtemperature protection
• Overcurrent protection with shutdown
• Supported by a full range of development tools including C compilers, macroassembler packages, emula扁平线电感tors, evaluation boards, HLL debuggers, programming tools, software packages
• Temperature Range TJ: -40 °C up to 150 °C
• Package PG-VQFN-48
• Green package (RoHS compliant)
TLE983x主要优势:
„„Complete system-on-chip (SoC) for ECU’s that communicate via LIN interface with main ECU
„„High-voltage monitoring inputs for off-board switch control
„„Highly flexible SoC through de电感器工作原理图dicated configuration registers for e.g. current and voltage settings as well as power saving modes
分享一颗用过不错的充电+升压二合一的芯片。
最大3A进3.5A出。
规格书是以前老的。
ASC8826移动电源2A进3A出二合一芯片.pdf(271.73KB,下载次数:330)2015-5-1815:27上传
点...
1 引 言目前，感应加热电源已广泛用于金属熔炼、透热、焊接、弯管、表面淬火等热加工和热处理行业。然而传统感应加热电源整流变换一般采用晶闸管相控整流或二极管不控整流方式，为获得较为稳定的直流电压，整流后...
变压器检修时更换绕组或绝缘、器身在空气中暴漏的时间超标，测量经绝缘电阻的吸收比证明变压器绕组受潮等情况下要进行变压器的干燥处理。变压器干燥处理模压电感器厂常见方法有：感应加热法、热风干燥法、烘箱干燥...